Specifications

3-42
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
General AXSM Configuration Procedures
MPLS partition without bringing down the port using the dnport command to change the PNNI VPI/VCI
ranges. Bringing down a port on a live network is usually not an option.
To create a resource partition for a port, use the following procedure.
Note You must add the PNNI controller and add a port before you create a resource partition for a port.
For instructions on adding the controller, refer to the Cisco MGX 8800/8900 Series
Configuration Guide, Release 5.2. For instructions on adding ports, see the “Adding ATM Ports”
section on page 3-27.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 Determine the port number to which you want to assign the resource partition. To display a list of the
ports, enter the following command:
M8950_DC.5.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum SCT Id ifType VPI minVPI maxVPI
State State Rate Rate (D:dflt (VNNI, (EVNNI,EVUNI)
used) VUNI)
----- ---- ----- ----- ---------- --------- ------ ------ ------ ------ ------
11 1.1 Up Up 5651320 5651320 5 NNI 0 0 0
This command displays all ports on the AXSM card in the ifNum (interface number) column.
Step 3 To create a resource partition, enter the addpart command:
addpart < ifNum > < partId > < ctrlrId > < egrminbw> < egrmaxbw > < ingminbw > < ingmaxbw > < minVpi >
<
maxVpi > < min V ci > < max V ci > < minConns > < maxConns >
Table 3-9 lists the parameters for configuring resource partitions.
Table 3-9 addpart Command Parameters
Parameter Description
if_num Logical interface (port) number. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
part_id The partition ID number. The ranges are as follows:
AXSM: 1–5
AXSM-E: 1–20