User guide

37
Release Notes for Cisco Router and Security Device Manager 2.5
OL-5009-20
Caveats
• CSCed91235
The router reloads when an NHRP tunnel interface is removed. This is a Cisco IOS caveat which
you may encounter when deleting a DMVPN tunnel. This caveat duplicates CSCed41641.
Workaround: There is no workaround for this problem.
• CSCin68829
If an Analog Modem or ISDN connection is deleted using Cisco SDM, the dialer interface may not
be deleted from the configuration and the router may reload. This is due to a Cisco IOS caveat,
CSCin69090. This occurs on routers using Cisco IOS images of Release 12.3(4)XG or later, or Cisco
IOS Release 12.3(7)T.
Workaround: There is no workaround for this problem.
• CSCed92739
On routers running Cisco IOS Release 12.3(6), Cisco IOS may reload if Cisco SDM is started using
HTTPS.
Workaround: Start Cisco SDM by entering http://ip-address. Do not use https://ip-address.
• CSCee67639
The Cisco SDM Express wizard may fail if the router is running Cisco IOS Release 12.3(9) and
there is not sufficient space in NVRAM to save the startup configuration. This problem should not
occur with new routers.
Workaround: If this problem occurs, use the CLI to remove unneeded files from NVRAM.
• CSCed13205
Cisco SDM does not issue the ntp update-calendar Cisco IOS command on Cisco 7200 routers if
there are no new settings to enter and if the Network Time Protocol (NTP) server was configured
using the CLI, only one NTP server IP address was provided and no ntp update-calendar Cisco IOS
command was present in the running configuration.
Workaround: Use Cisco SDM to delete the NTP server configuration entry, click Refresh, and then
re-create the entry, or make changes to the existing NTP server entry.
• CSCee71373
Because of a Cisco IOS issue (CSCee63313), if Cisco SDM is used to enable IPS on an interface,
and then used to disable IPS on that interface, the router crashes.
• CSCee65422
Due to a Cisco IOS issue (see CSCee58000), Cisco SDM is unable to configure a virtual auxiliary
port on Cisco 831, 836, or 837 routers running Cisco IOS Release 12.3(7)XR1.
Workaround: Load the rebuilt Cisco Release 12.3(7)XR2 image on the router when it becomes
available and then use Cisco SDM to configure a virtual auxiliary port.
• CSCeg57729
When Cisco SDM is installed on a PC, it cannot be launched if run from Netscape 7.1 or 7.2 and
popup blockers have been enabled.
Workaround: In Netscape, go to Edit > Preferences > Privacy and Security > Popup Windows.
In the Popup Windows section, uncheck Block unrequested popup windows, and then click Apply.
Relaunch Cisco SDM.