User guide

32
Release Notes for Cisco Router and Security Device Manager 2.5
OL-5009-20
Caveats
• CSCef53222
Cisco SDM filenames are case sensitive. If the Cisco SDM files are copied from the PC hard disk to
a flash card, File Explorer changes the names to uppercase. When this happens, Cisco SDM cannot
be invoked from this flash card.
Workaround: Before removing the flash card from the PC, restore the filenames to lowercase.
• CSCef77689
When the router is running a Cisco IOS image that does not support the show pppoe session
command, WAN troubleshooting may not report any reasons for failure or recommended actions for
PPPoE connections that are found to be down.
Workaround: None.
• CSCin54600
If a firewall is configured for an interface which already has a Management Access policy associated
with it, choosing Replace in the Merge/Replace dialog box might prevent access to certain
networks.
This occurs because choosing Replace causes the policy access control entries (ACEs) to be
disassociated from the interface but not from the vty or HTTP line.
Workaround: When running Firewall wizard on an interface configured with Management Access
policy, choose Merge option instead of Replace and proceed.
• CSCef73879
VPN troubleshooting may report a possible Maximum Transmission Unit (MTU) problem in the
passthrough network when the tunnel is up. If the VPN interface is a dialer interface configured on
an asynchronous interface, this problem may not always exist, and the displayed recommended
action will have no effect.
Workaround: Ignore this message and the corresponding recommendation.
• CSCef73395
Due to a problem with Cisco IOS, if a custom protocol is mapped to a port and the same custom
protocol is specified for matching under a classmap, and then the mapping of the custom protocol
is deleted from the configuration, Cisco IOS does not give any warning message that the user should
first delete the match protocol custom-01 commands that make use of the custom protocol
mapping.
Workaround: Do the following:
– Configure the custom protocol again.
– Remove all the match protocol statements that reference the custom protocol that you
configured.
– Remove the custom protocol from the configuration.
• CSCef52940
This problem is caused by Cisco IOS caveat CSCef52919. A user with privilege level 1 who is
associated with a view may be able to log in to Cisco SDM with a privilege level of 15. This occurs
when authentication authorization and accounting (AAA) is enabled, and a vty line is configured
with privilege level 2 through 15.
Workaround: Do not configure privilege 1-level users. The problem does not occur when users of
higher privilege levels are configured.