User guide

20
Release Notes for Cisco Router and Security Device Manager 2.5
OL-5009-20
Important Notes
!
ip domain-name yourdomain.com
!
interface FastEthernet0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-10/100 Ethernet$
ip address 10.10.10.1 255.255.255.248
description PC must be on the same subnet as this interface
no shutdown
!
ip http server
ip http secure-server
ip http authentication local
ip http timeout-policy idle 60 life 86400 requests 10000
!
line vty 0 4
privilege level 15
login local
transport input telnet
transport input telnet ssh
line vty 5 15
privilege level 15
login local
transport input telnet
transport input telnet ssh
Cisco SDM Merge and Replace Configuration Functions Fail Under Some
Conditions
The problem described here is caveat CSCsj21989. If you attempt to merge configuration changes made
using the Cisco SDM Config Editor feature, or replace the running configuration with a configuration
from the Config Editor, the router configuration will not be changed if there is a network device with a
Network Address Translation (NAT) IP address, or a cache engine in the connection between the PC and
the router. If you need to make changes to the router configuration that you would normally make using
the Cisco SDM Config Editor, use the Cisco IOS CLI instead.
Cisco SDM Security Dashboard May Display Threats Unrelated to Your
Cisco IOS IPS Installation
Some (or all) of the top threats you obtain using the Cisco SDM Security Dashboard may not pertain to
your Cisco IOS IPS installation. After you deploy the signatures applicable to the top threats displayed
by the Cisco SDM Security Dashboard, the dashboard may still display some (or all) top threats with a
red icon because applicable signatures could not be found. Those remaining top threats are unrelated to
your Cisco IOS IPS installation and not a danger to your router running Cisco IOS software.
Cisco SDM May not Launch Using IP Address of SSL VPN Gateway
This information provides more information about the caveat CSCek33306. When Cisco SDM attempts
to connect to a router with a SSL VPN gateway configured using the Cisco IOS CLI, it might not launch
from the IP address used by that gateway if the CLI statements necessary for Cisco SDM access are not
included.