Datasheet

© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 28 of 33
RAID Controller Options for Small Form Factor (SFF) Configuration:
The LSI MegaRAID controller can be installed in either PCIe slot on a UCS C200 server. The 9260-8i MegaRAID
card supports up to 8 SAS/SATA drives.
The LSI MegaRAID card (LSI
®
6G MegaRAID SAS 9260-8i) supports the following features:
●
Form Factor: PCIe Low Profile (H x L) = 2.72” x 6.60”
●
LSI SAS2108 (Liberator) ROC (RAID-On-a-Chip) Controller, at 800MHz
●
PCIe x8 card edge, also compatible with x16 lane slots, 5Gbps or 2.5Gbps serial transfer rate
●
Two Internal Mini SAS 4i Connectors
●
Eight channels of SAS/SATA at up to 6Gb/s
◦ SAS rates of 6.0Gb/s and 3.0Gb/s
◦ SATA rates of 3.0Gb/s and 1.5Gb/s
●
Hardware RAID (levels 0, 1, 5, 6, 10, 50 and 60)
●
Supports drive hot-plugging
●
5-Chip DDR2 On-Board memory running at 800 MHz (64-bit w/ ECC) for enhanced hardware RAID
performance
●
512MB on-board DDR2-800 cache arranged as 64Mx16 devices (1Gb capacity)
●
iBBU support: direct connected iBBU07 RAID Battery Back-up module for DDR2 DIMM refresh support
during a power failure
●
8MB CFI Compliant Flash ROM and a 32kB NVSRAM (non-volatile SRAM) for disk and drive setup
information storage
●
SES (System Enclosure Specification) connectivity through I2C cable or SGPIO
●
UART and JTAG debug ports
Refer to LSI
®
Mega RAID SAS 9260-8i Product Specification or visit the link below for a detailed description of this
board: http://www.lsi.com/storage_home/products_home/internal_raid/megaraid_sas/6gb_s_value_line/sas9260-
8i/index.html?locale=EN&remote=1.
Contents: Overview Detailed Views Base Unit Features Configuring Memory HDD
Option Cards RAID Software Services Memory Notes
Option Card Notes RAID Controller Notes Physical Specs Power Specs Environmental Specs