System information

Introduction
Using the Setup Wizard
Cisco RV215W Wireless-N VPN Firewall Administration Guide 8
1
Using the Setup Wizard
The Setup Wizard and Device Manager are supported on Microsoft Internet
Explorer 6.0 or later, Mozilla Firefox 3.0 or later, and Apple Safari 3.0 or later.
To use the Setup Wizard:
STEP 1 Start the computer that you connected to a LAN port.
Your computer becomes a DHCP client of the Cisco RV215W and receives an IP
address in the 192.168.1.xxx range.
STEP 2 Launch a web browser and enter 192.168.1.1 in the Address bar. This is the
default IP address of the Cisco RV215W.
A message appears about the site security certificate. The Cisco RV215W uses a
self-signed security certificate and this message appears because the
Cisco RV215W is not known to your computer.
STEP 3 Click Continue to this website (or the option shown on your particular web
browser) to go to the web site. The login page displays.
STEP 4 Enter the user name and password.
The default user name is cisco. The default password is cisco. Passwords are
case sensitive.
STEP 5 Click Log In. The Setup Wizard starts.
STEP 6 Follow the on-screen instructions to set up the Cisco RV215W.
The Setup Wizard tries to automatically detect and configure your connection. If it
cannot, the Setup Wizard might ask you for information about your Internet
connection. You might need to contact your ISP to obtain this information.
After the Setup Wizard is done configuring the Cisco RV215W, you are required to
change the default password. Follow the on-screen instructions. After changing
the default password, the Getting Started page appears.