System information

Configuring Networking
Configuring IPv6
Cisco RV215W Wireless-N VPN Firewall Administration Guide 57
2
To create a static route:
STEP 1 Choose Networking > IPv6 > IPv6 Static Routing.
STEP 2 In the list of static routes, click Add Row.
STEP 3 Enter this information:
STEP 4 Click Save.
To edit the settings of a route, select the route and click Edit. To delete a selected
route, click Delete. Click Save to apply changes.
Name Route name.
Destination IPv6 address of the destination host or network for
this route.
Prefix Length Number of prefix bits in the IPv6 address that define
the destination subnet.
Gateway IPv6 address of the gateway through which the
destination host or network can be reached.
Interface Interface for the route: LAN, WAN, or 6to4.
Metric Priority of the route. Choose a value between 2 and 15.
If multiple routes to the same destination exist, the
route with the lowest metric is used.
Active Check to make the route active. When you add a route
in an inactive state, it is listed in the routing table, but is
not used by the Cisco RV215W.
Entering an inactive route is useful if the route is not
available when you add the route. When the network
becomes available, you can enable the route.