System information

Configuring Networking
Configuring IPv6
Cisco RV215W Wireless-N VPN Firewall Administration Guide 55
2
To configure IPv6 LAN settings:
STEP 1 Choose Networking > IPv6 > IPv6 LAN Configuration.
STEP 2 Enter the following information to configure the IPv6 LAN address:
STEP 3 Click Save or continue to configure IPv6 DHCP LAN settings.
STEP 4 Enter the following information to configure the DHCPv6 settings:
IPv6 Address Enter the IPv6 address of the Cisco RV215W.
The default IPv6 address for the gateway is fec0::1
(or FEC0:0000:0000:0000:0000:0000:0000:0001).
You can change this 128-bit IPv6 address based on
your network requirements.
IPv6 Prefix Length Enter the IPv6 prefix length.
The IPv6 network (subnet) is identified by the initial
bits of the address called the prefix. By default, the
prefix is 64 bits long.
All hosts in the network have the identical initial bits
for their IPv6 address; you set the number of
common initial bits in the network addresses in this
field.
DHCP Status Check to enable the DHCPv6 server.
When enabled, the Cisco RV215W assigns an IP
address within a specified range and provides
additional information to any LAN endpoint that
requests DHCP addresses.
Domain Name (Optional) Domain name of the DHCPv6 server.
Server Preference Server preference level of this DHCP server. DHCP
advertise messages with the highest server
preference value to a LAN host are preferred over
other DHCP server advertise messages.
The default is 255.