System information

Configuring Networking
Configuring IPv6
Cisco RV215W Wireless-N VPN Firewall Administration Guide 53
2
STEP 3 Enter the following information (it might be necessary to contact your ISP to obtain
your PPPoE login information):
Username Username assigned to you by the ISP.
Password Password assigned to you by the ISP.
Connect on Demand If your ISP charges based on the amount of time
that you are connected, select the radio button.
When selected, the Internet connection is active
only when traffic is present. If the connection is
idle—that is, no traffic is flowing—the connection is
closed. In the Max Idle Time field, enter the number
of minutes that must elapse with no traffic detected
on the link before the link is shut down .
Keep Alive Keeps the WAN link up by sending a keep alive
message through the port. In the redial period field,
enter the number of seconds after which the
Cisco RV215W attempts to reconnect if it is
disconnected.
Authentication Type Authentication types:
Auto-negotiation—A server sends a configuration
request specifying the security algorithm set on
the server. The Cisco RV215W replies with its
authentication credentials, including the security
type sent by the server.
PAP—Use the Password Authentication Protocol
(PAP) to connect to the ISP.
CHAP—Use Challenge Handshake Authentication
Protocol (CHAP) to connect with the ISP.
MS-CHAP or MS-CHAPv2—Use Microsoft
Challenge Handshake Authentication Protocol to
connect to the ISP.
Service Name Name that your ISP might require to log onto the
PPPoE server.