System information

Configuring Networking
Configuring IPv6
Cisco RV215W Wireless-N VPN Firewall Administration Guide 52
2
Configuring a Static IPv6 WAN Address
If your ISP assigns you a fixed address to access the WAN, configure the
Cisco RV215W to use a static IPv6 address.
To configure a static IPv6 WAN address:
STEP 1 Choose Networking > IPv6 > IPv6 WAN Configuration.
STEP 2 From the WAN Connection Type menu, select Static IPv6.
STEP 3 Enter this information:
STEP 4 Click Save.
Configuring PPPoE IPv6 Settings
You can run IPv4 PPPoE, IPv6 PPPoE, or both. If you run both, your IPv6 WAN
PPPoE settings must match your IPv4 WAN PPPoE settings. If they do not match, a
message displays asking if you want to set the IPv6 protocol to match the IPv4
protocol. See Configuring PPPoE. for more information
To configure the PPPoE IPv6 settings:
STEP 1 Choose Networking > IPv6 > IPv6 WAN Configuration.
STEP 2 In the WAN Connection Type field, choose PPPoE IPv6.
IPv6 Address IPv6 address of the WAN port.
IPv6 Prefix Length Length of the IPv6 prefix(typically defined by the
ISP). The IPv6 network (subnet) is identified by the
initial bits of the address called the prefix. All hosts
in the subnetwork have the identical prefix.
For example, in the IPv6 address
2001:0DB8:AC10:FE01:: the prefix is 2001.
Default IPv6 Gateway IPv6 address of the default gateway. This is
typically the IP address of the server at the ISP.
Static DNS 1 IP address of the primary IPv6 DNS server.
Static DNS 2 IP address of the secondary IPv6 DNS server.