User guide

E-76
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Appendix E Real-Time Counters
Common/Card-BearerEndPoint—Supported Real-Time Counters
E.24 Common/Card-BearerEndPoint—Supported Real-Time
Counters
This section includes the following information:
• Bearer Counters—platform EQ NOTARES
Table E-65 Bearer Counters—platform EQ NOTARES
Applicability Counter Name MIB Object Name Description
All Versions Channel Id bearerCid This attribute defines the CID (Channel ID
associated with this bearer connection.This refers
to the same value as vismAal2CidNum in the
vismAal2CidCnfTable.
All Versions LCN bearerLcn This attribute defines the PVC or LCN number to
which this bearer connection is associated with.
This refers to the same value as in vismChanNum
in vismChanCnfGrp table.
All Versions Sent Packets bearerSentPkts This attribute defines the count of packets sent
towards the network since setup.
All Versions Received Packets bearerRcvdPkts This attribute defines the count of packets received
from the network since setup.
All Versions Sent Octets bearerSentOctets This attribute defines the count of bytes sent
towards the network since this connection setup.
All Versions Received Octets bearerRcvdOctets This attribute defines the count of bytes received
from the network since this connection setup.
All Versions Lost Packets bearerLostPkts This attribute defines the count of packets lost in
the egress direction (from the network). This is a
computed number based on the expected number of
packets and the actual number of packets arrived
from the network. Currently this object is not used.
All Versions Jitter bearerJitter This attribute defines the jitter (a.k.a interarrival
jitter) This value is determined by the DSP and
obtained by the HOST processor upon querying the
DSP on a periodic basis. This value is expressed in
units of milliseconds. Currently this object is not
used.
All Versions Latency bearerLatency This attribute defines the latency (a.k.a end-to-end
average transmission delay for a voice packet. This
value is expressed in units of milliseconds.
Currently this object is not used.