User guide

E-58
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Appendix E Real-Time Counters
RPM-ETHERNET-Line—Supported Real-Time Counters
All Versions Ignored In Packets locIfInIgnored Number of input packets which were simply ignored by
this interface.
All Versions Internal Resets locIfResets Number of times the interface internally reset.
All Versions Output Collisions locIfCollisions The number of output collisions detected on this
interface.
All Versions Input Queue Drops locIfInputQueueDrops The number of packets dropped because the input
queue was full.
All Versions Output Queue
Drops
locIfOutputQueueDrops The number of packets dropped because the output
queue was full.
Table E-47 Category—Ethernet Counters
Applicability Counter Name MIB Object Name Description
All Versions Small Packets locIfInRunts Number of packets input which were smaller than the
allowable physical media permitted.
All Versions Large Packets locIfInGiants Number of input packets which were larger than the
physical media permitted.
All Versions Misaligned Packets locIfInFrame Number of input packet which were misaligned.
All Versions dot3StatsIndex dot3StatsIndex An index value that uniquely identifies an interface to
an ethernet-like medium. The interface identified by a
particular value of this index is the same interface as
identified by the same value of ifIndex.
All Versions Alignments dot3StatsAlignmentErrors A count of frames received on a particular interface
that are not an integral number of octets in length and
do not pass the FCS check. The count represented by
an instance of this object is incremented when the
alignmentError status is returned by the MAC service
to the LLC (or other MAC user). Received frames for
which multiple error conditions obtain are, according
to the conventions of IEEE 802.3 Layer Management,
counted exclusively according to the error status
presented to the LLC.
All Versions SQE Test Errors dot3StatsSQETestErrors A count of times that the SQE TEST ERROR message
is generated by the PLS sublayer for a particular
interface. The SQE TEST ERROR message is defined
in section 7.2.2.2.4 of ANSI/IEEE 802.3-1985 and its
generation is described in section 7.2.4.6 of the same
document.
Table E-46 Category—Interface Counters (continued)
Applicability Counter Name MIB Object Name Description