User guide
B-89
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Appendix B Error Messages
Cisco MGM Server Error Messages
Error Message EID-603: Incorrect trap recvfrom with errno =
value
.
Recommended Action
This is an internal processing error. If the problem persists, contact Cisco
technical support with this error message.
Error Message EID-604: Failed to parse SNMP trap definition file
filename
.
Recommended Action
The traps.lst file in the bin directory where the Cisco MGM server was
installed is corrupted. Delete the traps.lst file and restart the application.
Error Message EID-605: Failed to recover alarm sequence #
number
to #
number
for NE
ID
.
Recommended Action Cisco MGM could not recover all alarms from the NE. There might be events
missing in the Alarm Log due to connectivity problems or mangled packets. However, the Alarm
Browser will reflect the correct alarm information. In the Domain Explorer window, choose
Fault > Alarm Browser to view the current alarms.
Error Message EID-704: Invalid SNMP recvfrom with errno =
value
.
Recommended Action
This is an internal processing error. If the problem persists, contact Cisco
technical support with this error message.
Error Message EID-705: Invalid SNMP sendto with errno =
value
.
Recommended Action
This is an internal processing error. If the problem persists, contact Cisco
technical support with this error message.
Error Message EID-706: SNMP trap received from unknown NE
ID
.
Recommended Action SNMP traps are being received from an NE that is not configured on the Cisco
MGM server. Check the configured IP addresses for all NEs by viewing the configuration files
(startup-config). The IP addresses should match the IP address of the interface used in the
“snmp-server trap-source IF” CLI in the NE configuration.
Error Message EID-1402: The OSI daemon lockfile
value
is missing.
Recommended Action
This is an internal processing error. If the problem persists, contact Cisco
technical support with this error message.
Error Message EID-1403: The OSI daemon lockfile does not contain the PID.
Recommended Action
This is an internal processing error. If the problem persists, contact Cisco
technical support with this error message.