User guide

9-14
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 9 Managing Faults
Is the Service Working?
These tasks are used to diagnose network elements with the Diagnostic Center:
• 9.4.4 Displaying the Status of all Nodes in the Network
• 9.4.5 Displaying the Status of a Node
• 9.4.6 Displaying the Status of a Card
• 9.4.7 Displaying the Status for Lines or Ports
• 9.4.8 Displaying the Status for Paths in a Loopback for the VXSM-OC3 Card
• 9.4.9 Displaying the Status for Lines in a Loopback
These tasks are used to diagnose the voice cards for both Voice Service Module (VXSM) and Voice
Interworking Service Module (VISM-PR):
• 9.4.10 Displaying the Paths in Loopback for the VXSM-OC3 Card
• 9.4.11 Displaying the Status for a Bit Error Rate Test for the Voice Cards
• 9.4.12 Displaying the Lines in Loopback for the Voice Cards
• 9.4.13 Managing the Status for the VXSM Features
• 9.4.14 Managing the Status for the VISM-PR Features
This task is used to diagnose connections:
• 9.4.15 Diagnosing Connections
These tasks describe the Bit Error Rate Test (BERT) used to verify the integrity of a network element:
• 9.4.16 Bit Error Rate Test
• 9.4.17 Configuring Bit Error Rate Test
• 9.4.18 Displaying Bit Error Rate Test
9.4.1 Viewing Service Status
You can monitor the different services that run on the server. To view service status, choose
Administration > Service Monitor in the Domain Explorer window. The Service Monitor Table
appears and displays the status of the services that are currently running on the server. The table displays
the following information:
• Service Name—Name of the service
• Logged In At—Time that the user last logged in
• IP Address—IP address of the service
• Session ID—Unique session ID
Note The showmgm command from the CLI is an alternate way of viewing processes or services that are
currently running on the server.