User guide

6-178
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure VISM-PR Cards?
Figure 6-94 Configuration Center—VISM-PR DSX0 Parameters Window, DSX0 Parameters
Category
Step 5
Complete or modify the fields.
Note Table 6-79 describes fields in the VISM-PR DSX0 Parameters window, DSX0 Parameters
category.
Step 6 Click Apply to configure the DSX0 parameters.
Note For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.
Table 6-79 Field Descriptions for the VISM-PR DSX0 Parameters Window, DSX0 Parameters
Category
Field Name Description
DS0 Number DS0 number.
Robbed Bit Signalling Indicates if robbed bit signalling is turned on or off for a given DS0. This only
applies to DS0s on a DS1 link.
Idle Code Contains the code transmitted in the ABCD bits when the DS0 is not
connected and DS0TransmitCodesEnable is disabled. Possible values are
0-15.
Seized Code Contains the code transmitted in the ABCD bits when the DS0 is connected
and DS0TransmitCodesEnable is enabled. Possible values are 0-15.