User guide

6-177
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure VISM-PR Cards?
6.9.4.5.2 Viewing DS0 Endpoints
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the DS1 line under the VISM-PR card.
Step 3 Click the DSX0 tab. A table appears listing the DS0 endpoints.
6.9.4.5.3 Configuring DS0 Parameters
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the DS1 line under the VISM-PR card.
Step 3 Click the DSX0 tab. A table appears listing the DS0 endpoints.
Step 4 Click on a DS0 entry and then click Details. The DSX0 Parameters window appears, with the DSX0
Parameters category selected by default.
Table 6-78 Field Descriptions for the VISM-PR Create Endpoints Config Window
Field Name Description
Endpoint Number Identifies endpoint as it is known by the NE. Index to this table. The range is
from 1-248.
DS0 Number Bitmap of DS0s used by the endpoint. Bit positions set to 1 represent DS0s
used by the endpoint. The position corresponds to the DS0 number. The
following are possible ranges:
• 1-24 for T1 lines
• 1-31 for non-CAS E1 lines
• 1-15, 17-31 for CAS E1 lines
Name Identifies endpoint as it is known by the MGC. If MG and MGC use a
mutually agreed upon convention, this may be supplied by the agent, for
example, it may be read-only.
Speed (kilo bits per
second)
Indicates the endpoint’s bandwidth, in Kbps. Typically, this will be 64 times
the number of channels terminated by the endpoint.
State Indicates the state of the endpoint.