User guide

6-175
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure VISM-PR Cards?
6.9.4.5 Adding and Configuring DS0 Endpoints on Lines
To add and configure DS0 endpoints on lines, complete the following steps:
Step 1 Add DS0 endpoints to lines—See 6.9.4.5.1 Adding DS0 Endpoints to Lines for VISM-PR, page 6-175.
Step 2 (Optional) View DS0 endpoints—See 6.9.4.5.2 Viewing DS0 Endpoints, page 6-177.
Step 3 Configure DS0 parameters—See 6.9.4.5.3 Configuring DS0 Parameters, page 6-177.
6.9.4.5.1 Adding DS0 Endpoints to Lines for VISM-PR
To add DS0 endpoints to lines for VISM-PR T1 or E1 lines:
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the DS1 line under the VISM-PR card.
Step 3 Click the EndPoints Config tab.
Step 4 Click Create to display the Create Endpoints Config window.
LAPD Side (User or
N/W)
Specifies whether the LAPD stack is on the user or network side. This object
can be set when the row is created, but cannot be modified for an existing row.
LAPD Trunk Type Indicates if the line is configured for trunking or PRI-BH.
Table 6-77 Field Descriptions for the VISM-PR Create LAPD Channel Parameters Window
(continued)
Field Name Description