User guide

6-167
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure VISM-PR Cards?
6.9.4.3.4 Configuring ISDN PRI Backhaul for VISM-PR
Step 1 Create a session set:
a. From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG >
Configuration Center.
b. Under the Elements tab, within the node, double-click the VISM-PR card.
c. Click the MG Controller tab.
d. Choose the RUDP Session Set option from the Category drop-down arrow.
e. Click Create. The Create RUDP Session Set window appears.
Table 6-75 Configuration Center—VISM-PR Media Gateway Tab, Bearer Traffic Category
Field Name Description
Bearer N/W Type Network type to transport bearer traffic. Values are IP or ATM.
Bearer VC Type VC type to transport bearer traffic. Values are PVC or SVC.
Bearer Connection Type Connection type used to transport bearer traffic. If the Bearer N/W Type
is set to IP, then the value of this object must be set to not applicable.
Bearer Continuity Test Defines whether the bearer continuity test for a connection will be
performed or not at the time of call setup.
Bearer Continuity Timer CO4 (bearer continuity) timer in milliseconds.
Aggregate Traffic Clipping Enables or disables the aggregate traffic clipping policy applicable to all
bearer traffic generated at the VISM-PR card.
Aggregate SVC Bandwidth
(cells per second)
Used for AAL2 SVC aggregate SVC Connection Admission Control
(CAC) and also for aggregate traffic clipping at VISM-PR card when
Aggregate Traffic Clipping is enabled.