User guide

6-159
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure VISM-PR Cards?
To configure the gateway control protocol port for VISM-PR, complete the following steps:
Step 1 Configure a port number for a particular call agent and protocol:
a. From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG >
Configuration Center.
b. Under the Elements tab, within the node, double-click the VISM-PR card.
c. Click the XGCP tab.
d. Choose the XGCP Peers option from the Category drop-down arrow.
e. Click on a peer entry, then click Details. The XGCP Peers window appears.
Figure 6-82 Configuration Center—VISM-PR XGCP Peers Window
Note Table 6-74 describes fields in the VISM-PR XGCP tab, XGCP Peers option.
f. Click Apply.
Step 2 Specify the maximum waiting time before a Restart in Progress (RSIP) message is sent to the call agent:
a. Within the XGCP tab, choose the XGCP Parameters option from the Category drop-down arrow.