User guide

6-141
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure VISM-PR Cards?
6.9.2.4 Configuring ECAN for VISM-PR
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the DS1 line under the VISM-PR card.
Step 3 Click the VISM Specific DS1 tab. The VISM Line Config option appears by default in the Category
drop-down arrow.
Note For a detailed description of the VISM Line Config option, see section 6.9.2.1.2 Configuring
Signaling on the T1 or E1 Line, page 6-133.
Step 4 Choose the appropriate option from the Ecan Enable drop-down arrow.
Note Table 6-67 describes fields in the VISM Specific DS1 tab, VISM Line Config category.
For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.
6.9.3 Configuring Jitter on VISM-PR Cards
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the VISM-PR card.
Step 3 Click the CODECs tab.
Step 4 Choose the Generic CODEC Parameters option from the Category drop-down arrow.
Step 5 Click on a CODEC entry, then click Details. The Jitter Buffer window appears.