User guide

6-134
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure VISM-PR Cards?
Figure 6-67 Configuration Center—VISM-PR Specific DS1 Tab, VISM Line Config Category
Step 4
Choose one of the following options to configure signaling on the line in the Signaling Type drop-down
arrow:
• cas
• ccs
• none
Step 5 Configure additional parameters as desired.
Note Table 6-67 describes fields in the VISM-PR Specific DS1 tab, VISM Line Config category.
Step 6 Click Apply to configure signaling on the T1 or E1 line.
Note For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.