User guide

6-130
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure VISM-PR Cards?
6.9.2 Configuring TDM for VISM-PR
Figure 6-65 Process for Configuring TDM for VISM-PR
In order to configure the Time Division Multiplexing (TDM) on a VISM-PR card, you must perform the
following steps:
Step 1 Configure T1/E1 lines—See 6.9.2.1 Configuring T1 and E1 Lines for VISM-PR, page 6-131).
Step 2 (Optional) Place T1/E1 lines in or out of service—See 6.9.2.2 Placing T1 or E1 Lines In or Out of
Service, page 6-139.
Step 3 (Optional) Add bulk distribution—See 6.9.2.3 Adding Bulk Distribution Using SRME, page 6-139.
Step 4 Configure Echo Cancellation (ECAN)—See 6.9.2.4 Configuring ECAN for VISM-PR, page 6-141.
130011
Configure
T1/E1 lines
(Optional) Place T1/E1
lines in or out of service
(Optional) Add bulk
distribution
Configure Echo
Cancellation (ECAN)