User guide

6-123
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure VISM-PR Cards?
6.9.1.1 Creating a Virtual Port for VISM-PR
Note Only one virtual port is allowed on a VISM-PR card.
To create a virtual port for the VISM-PR card:
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the VISM-PR card.
Step 3 Click the Port tab to display the port table.
Step 4 Click Create to display the Create Port window.
Figure 6-61 Configuration Center—VISM-PR Create Port Window
Step 5
Complete the fields.
Note When you create an ATM port on a VISM-PR card, the bandwidth, VPI range, and VCI range
are determined.
Step 6 Click Create to create a virtual port for VISM-PR.
The added port is not detected by the controller until you create a resource partition. For more
information, see section 6.9.1.2 Creating a Resource Partition for VISM-PR, page 6-124.