User guide

6-120
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure RPM Cards?
6.8.3 Saving the Run-Time Configuration for RPM
Once you make any changes to the RPM card, such as creating or modifying a resource partition or an
ATM subinterface, or adding connections to the RPM card, to make your changes permanent and survive
after a reboot, you must save the run-time configuration on the RPM card.
Note For details on adding connections, see Chapter 7, “Provisioning Connections.”
Step 1 From the Domain Explorer window, choose Configuration > MGX 8880/8850 MG > Configuration
Center.
Step 2 Under the Elements tab, within the node, double-click the RPM card. The Card tab appears, with the
Front Card Configuration category selected by default.
Step 3 Click the Save Running Config button. The status of the operation appears in the lower left of the
window.
Table 6-61 Field Descriptions for the RPM Ports Create/Details Window
Field Name Description
Main Interface Specifies the main interface.
Subinterface Num Specifies the subinterface.
Adapter IF Maps to the RPMs port adapter interface. Currently only one port adapter
interface (switch 1) is supported.
IfType Specifies the link type of this subinterface.
IP Address Specifies the 4-octet IP address of this subinterface. The IP address is the same
as the one used to set up the slave end of the connection on the VXSM card.
Subnet Mask Specifies the 4-octet subnet mask of this subinterface. An example subnet
mask is 255.255.255.0.
Admin Status Specifies the administrative status of this subinterface.
Oper Status Current operational state of the subinterface.
Descriptor Port descriptor.