User guide

6-70
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure VXSM Cards?
Note Table 6-36 describes fields in the VXSM Path Config tab, Paths category.
f. Click Apply.
Note For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables,
page 6-9.
Step 3 Enable the DS1/E1 line:
a. Under the Elements tab, within the node, expand the VXSM OC3 card and expand the SONET line,
STS path, and VT path that contain the DS1/E1 line you want to enable. Double-click on the DS1/E1
line. The DS1/E1 Path tab appears, with the DS1/E1 Line Info option selected by default.
b. From the Admin Status drop-down arrow, choose the up option to enable the STS path.
Note Table 6-37 describes fields in the VXSM DS1/E1 Path tab, DS1/E1 Line Info category.
c. Click Apply.
Note For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables,
page 6-9.
Table 6-35 Field Descriptions for the VXSM Line Config Tab, Sonet Line Config Category
Field Name Description
Speed (Mbps) An estimate of the interface’s current bandwidth in units of 1,000,000 bits per
second.
Enable Desired state of the interface:
• up—enables the line
• down—disables the line
Loopback Type Desired loopback mode configuration of the line:
• noLoopback—Specifies no loopback state.
• lineLocal—Signal sent at the line is looped back through the device.
• lineRemote—Signal sent does not go through the device but is looped
back out.
Clock Source Specifies the source of the transmit clock.
Frame Scramble Enables or disables the scrambling option in the line.
Line Type Configured line type.
Descriptor Line descriptor.