User guide

6-68
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure VXSM Cards?
Figure 6-33 Configuration Center—VXSM Line Config Tab, Sonet Medium Config Category
Step 4
In the Medium Type field, click on the drop-down arrow to choose SDH.
Note Table 6-34 describes fields in the VXSM Line Config tab, Sonet Medium Config category.
Step 5 Click Apply to change the line type to SDH.
Note Changing the line type to SDH on the first line trickles down to the other lines.
For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.
Table 6-34 Field Descriptions for the VXSM Line Config Tab, Sonet Medium Config Category
Field Name Description
Medium Type Identifies whether a SONET or SDH signal is used across the interface.
Time Elapsed Number of seconds (including partial seconds) elasped since the beginning of
the current measurement period.