User guide

6-53
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure AXSM Cards?
6.6.4 Creating or Modifying AXSM Sonet Line APSs
You can configure the SONET line to have Automatic Protection Switching (APS). SRM or AXSME
cards can be configured for APS.
If you are setting up APS on multiple cards, you must first set up an APS connector and then set up
redundancy on the node (for details on setting up redundancy, see 5.5.1 Configuring Card Redundancy,
page 5-49.)
Note This tab is only applicable for OC-type AXSM cards, and not T3 or T1-type AXSM cards.
Step 1 From the Domain Explorer window, select the node from the Hierarchy pane and choose
Configuration > MGX 8880/8850 MG > Configuration Center. The Configuration window for the
selected node opens.
Step 2 Double-click an AXSM card.
Table 6-26 Field Descriptions for the AXSM DS3 Line Config Tab, Plcp Alarm Category
Field Name Description
Plcp Statistical Alarm
Severity
Severity of PLCP statistical alarm.
15 Min BIP8Cv
Threshold
If this value is exceeded in a 15 minute or sliding 24 hour window, a statistical
alarm will be declared.
24 Hr BIP8Cv
Threshold
15 Min BIP8ES
Threshold
24 Hr BIP8ES
Threshold
15 Min BIP8SES
Threshold
24 Hr BIP8SES
Threshold
15 Min BIP8SEFS
Threshold
24 HR BIP8SEFS
Threshold
15 Min BIP8UAS
Threshold
24 Hr BIP8UAS
Threshold
Plcp Line Alarm
Status
Bitmap of the DS3 line alarms.
Plcp Line Stat Alarm
State
Bitmap of the DS3 Plcp line statistical alarms.