User guide

6-48
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure AXSM Cards?
Step 4 Choose the Up option from the Interface Status drop-down arrow.
Step 5 (Optional) Verify or modify additional fields, as desired.
Note Table 6-22 describes fields in the AXSM DS3 Line Config tab, Line Config category.
For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.
Table 6-22 Field Descriptions for the AXSM DS3 Line Config Tab, Line Config Category
Field Name Description
CDSX3 Line Type Type of DS3 C-bit or E3 application implementing this interface.
DSX3 Line Type Type of DS3 C-bit or E3 application implementing this interface.
Interface Status State of the interface.
Alarm Indication
Signal Bits
When check is set, the Alarm Indication Signal (AIS) is declared when
“1010...”b is found and C-bits are all zero. When ignore is set, an AIS
condition is declared when “1010...”b is detected irrespective of the state of
the C-bits.
Rcv FEAC Validation Specifies the Far End Alarm and Control (FEAC) code validation criteria.
Out of Frame Criteria Specifies the Out of Frame decision criteria.
Time Elapsed Seconds Number of seconds that have elapsed since the beginning of the near end
current error measurement period.
Valid Intervals Number of previous near end intervals for which data was collected. This
value will be 96 unless the interface was brought online within the last 24
hours, in which case the value will be the number of complete 15 minute near
end intervals since the interface has been online.
Line Coding Type of zero code suppression used on this interface.
Send Code Type Type of code that is being sent across the DS3/E3 interface by the device.
Circuit Identifier Variable contains the transmission vendor’s circuit identifier, to facilitate
troubleshooting.
Loopback
Configuration
Represents the desired loopback configuration of the DS/E3 interface.
dsx3NoLoop means not in the loopback state. Additional values include:
• dsx3PayLoadLoop
• dsx3LineLoop
• dsx3OtherLoop
• dsx3InwardLoop
• dsx3DualLoop
Interface Line Status Line status of the interface.
Transmit Clock
Source
Source of the transmit clock.