User guide
6-37
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure AXSM Cards?
Table 6-16 Field Descriptions for the AXSM Line Config Tab, Sonet Medium Config Category
Field Name Description
Medium Type Identifies whether a SONET or SDH signal is used across the interface.
Time Elapsed Number of seconds (including partial seconds) elasped since the beginning of
the current measurement period.
Valid Intervals Number of previous 15 minute intervals for which data was collected.
Line Coding Describes the line coding for the interface signals:
• sonetMediumOther
• sonetMediumB3ZS
• sonetMediumCMI
• sonetMediumNRZ
• sonetMediumRZ
Note The B3ZS and CMI are used for electrical SONET/SDH signals
(STS-1 and STS-3). The NRZ is used for the optical SONET/SDH
signals.
Line Type Describes the line type for this interface:
• sonetOther
• sonetShortSingleMode
• sonetLongSingleMode
• sonetMultimode
• sonetCoax
• sonetUTP
Note The line types are short-and long-range single-mode fiber or
multi-mode fiber interfaces, coax, and UTP for electrical interfaces.
Circuit ID The transmission vendor’s circuit identifier, for the purpose of facilitating
troubleshooting.
Note The circuit identifier, if available, is also represented by
ifPhysAddress.