User guide

6-35
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure AXSM Cards?
Step 4 Choose the Up option from the Enable drop-down arrow.
Step 5 (Optional) Verify or modify additional fields, as desired.
Note Table 6-15 describes fields in the AXSM Line Config tab, Sonet Line Config category.
For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.
Table 6-15 Field Descriptions for the AXSM Line Config Tab, Sonet Line Config Category
Field Name Description
Speed (Mbps) An estimate of the interface’s current bandwidth in units of 1,000,000 bits per
second.
Enable Desired state of the interface:
• up—enables the line
• down—disables the line
Loopback Type Desired loopback mode configuration of the line:
• noLoopback—Specifies no loopback state.
• lineLocal—Signal sent at the line is looped back through the device.
• lineRemote—Signal sent does not go through the device but is looped
back out.
Clock Source Specifies the source of the transmit clock.
Frame Scramble Enables or disables the scrambling option in the line.
Line Type Configured line type.
Descriptor Line descriptor.