User guide

6-18
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter6 Configuring Hardware
How Do I Configure Cisco MGX 8880 and 8850 Nodes?
Front, Back, and
Sec Back Card
Configuration
(continued)
Secondary
Description (RPM
only)
Secondary back card description.
Secondary Serial
Number (RPM
only)
Secondary back card serial number.
Secondary
Hardware Revision
(RPM only)
Secondary back card hardware revision.
Secondary
Firmware Revision
(RPM only)
Secondary back card firmware revision.
Secondary
Operational Status
(RPM only)
Secondary back card operational status.
Save Running
Config button
(RPM only)
Allows you to save any configuration changes on the router,
in order to keep those changes after a reboot.
System
Information (RPM
only)
Sys Description Textual description of the system entity.
Up Time Time (in hundredths of a second) since the network
management portion of the system was last re-initialized.
Contact ID and contact information of the contact person for this
managed node.
Node Name Administratively assigned name for the managed node.
Location Physical location of the node.
Services Indicates a set of services that the system offers.
Entity Sensors,
Entity Sensors Tab
Sensor Description Textual description of the sensor.
Sensor Type Type of data reported by the entSensorValue. This variable
is set by the agent at startup and the value does not change
during operation.
Sensor Scale Indicates the exponent to apply to sensor values reported by
entSensorValue. This variable is set by the agent at startup
and the value does not change during operation.
Sensor Value Reports the most recent measurement detected by the
sensor.
Sensor State Indicates the present operational state of the sensor.
Table 6-9 Field Descriptions for the Cards Tab (continued)
Category Field Name Description