User guide

6-17
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 6 Configuring Hardware
How Do I Configure Cisco MGX 8880 and 8850 Nodes?
Note The Back Card Configuration or Sec Back Card Configuration options are read-only.
Step 3 (Optional) Within the Front Card Configuration option, enter the card descriptor in the Descriptor
field.
Note The Descriptor field is valid for the whole Card Configuration, but is available only from the
first category of that card configuration, in this case the Front Card Configuration.
Step 4 (Optional) Within the System Information option, enter the Node Name.
Step 5 Click Apply to modify the card descriptor and to verify the information for the card is valid.
Note For a description of all buttons within this tab, see section 6.2.3 Navigating Within Tables, page
6-9.
Table 6-9 Field Descriptions for the Cards Tab
Category Field Name Description
Front, Back, and
Sec Back Card
Configuration
(applicable fields
vary for each)
(Operational)
Status
Operational state of the module.
Card Description Front card description.
Admin Status Administrative control of the module.
Type Textual description of physical entity.
Slot Number Number of the physical entity.
Hardware (HW)
Revision
Vendor-specific hardware description string.
Firmware (FW)
Revision
Vendor-specific firmware description string.
SW Revision Vendor-specific software description string.
Serial Number Vendor-specific serial number string.
Orderable Part No Name of the manufacturer.
Reset Reason Reason for last reset.
Descriptor Card descriptor.