User guide

5-21
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Chapter 5 Maintaining an Efficient Network
How Do I Monitor the Network?
Step 2 Press Enter.
The chosen NE is displayed along with the current status for each card.
Step 3 Click the Front View tab or Rear View tab of the NE. The default is the front view.
Step 4 Check the status of the NE from Inspector View.
5.2.4 Monitoring a Card with Chassis View
You can select a card to monitor when the objects are associated with a particular card. The following
settings are monitored using the objects:
• SONET interface settings
• Interface partition settings
• Revision numbers of hardware, software, and firmware installed on the card
• Lines, interfaces, and ports on the card
To monitor a card:
Step 1 In Chassis View, there are two ways to choose the card:
• Choose the card from the Hierarchy pane, or
• Click the slot that you want to display from the node view. A yellow border highlights the chosen
slot in the node view.
Step 2 Click the Front View tab or Rear View tab of the node. The default is the front view. See Figure 5-2.
Step 3 Check the status of the card from Inspector View.
Step 4 Right-click the slot and choose the corresponding application. If you want to configure the settings for
the card, choose Configuration Center.
The Configuration Center is launched with a view of the network elements.