manual

5-9
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Display Assembly—Part Number CTS500-32-INTDISP=
Replacing the Display Assembly—Part Number
CTS500-32-INTDISP=
The following section provides you with the procedure to replace the display and includes the following
topics:
• Tools required, page 5-9
• Replacing the Display Assembly—Video, page 5-9
• Replacing the Display Assembly—Detailed Steps, page 5-9
Tools required
One #2 Phillips screwdriver
Note Two people are required for installation to remove the display assembly from the column.
Replacing the Display Assembly—Video
For videos that show removal and replacement of the display, complete the tasks as shown in the
following URL.
Step 1 Remove the codec by completing the tasks in the following video:
http://www.cisco.com/en/US/docs/telepresence/cts_500/cts_500_32/assembly/guide/video/
fru_videos/removing_the_codec.html
Step 2 Remove the display by completing the tasks in the following video:
http://www.cisco.com/en/US/docs/telepresence/cts_500/cts_500_32/assembly/guide/video/
fru_videos/removing_the_display.html
Step 3 Install the new display by completing the tasks in the following video:
http://www.cisco.com/en/US/docs/telepresence/cts_500/cts_500_32/assembly/guide/video/
fru_videos/installing_the_display.html
Step 4 Replace the existing codec into the new display assembly by completing the tasks in the following video:
http://www.cisco.com/en/US/docs/telepresence/cts_500/cts_500_32/assembly/guide/video/
fru_videos/installing_the_codec.html
Replacing the Display Assembly—Detailed Steps
To replace the display assembly, complete the following steps:
Step 1 Turn off the system using the on/off switch on the bottom of the column (near the floor).
Step 2 Remove the rear codec cover.