manual

5-8
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Codec—Part Number CTS-CODEC-SING-G1= or CTS-CODEC-SING1CH= (China Only)
Step 12 Use the tie-wraps to route and rearrange the cables. Callout 1 in Figure 5-4 shows the location of one of
the two tie-wrap.
Correct cable routing ensures that the codec cover can be placed on the rear of the display. Therefore,
make sure that the cables do not cover the mounting holes for the codec cover, and that they do not
protrude so that you cannot attach the codec cover.
Step 13 Place the rear codec cover back on the display.
Step 14 Complete the following steps to configure the new codec in Cisco Unified Communications Manager:
a. Open a browser on a computer connected to the network.
b. Access the Cisco Unified Communications Manager interface.
c. Add the Room Email ID of the previous codec to the new codec.
d. Make sure the new codec's status is registered.
e. Delete the MAC address of the previous codec from the Cisco Unified CM application user profile
that is used in Cisco TelePresence Manager (CTS-Manager).
f. Add the new codec to the application user profile and click Save.
Step 15 Turn the codec power switch to the On position.
See Figure 5-2 for the location of this switch.
Step 16 Open a browser on a computer connected to the network.
Step 17 Type the IP address of the primary codec unit into the browser address bar.
Step 18 Enter the required information at the login screen. The Cisco TelePresence Administrator window
appears.
Step 19 Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 20 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working properly.
See the “Manual First-Time Setup” section on page 4-31 for more information.
Step 21 Perform the Auto Adjust camera setup procedure. This sets the white balance to the correct levels. See
the “Manual First-Time Setup” section on page 4-31 for more information.
Step 22 Configure the codec in CTS-Manager by completing the following steps:
a. Log in to CTS-Manager as SysAdmin or Administrator.
b. Go to Configure > Application Settings.
c. Disable the Meeting Notification Email by selecting No for Enable Feature and clicking Apply.
d. Go to Configure > Unified CM.
e. Select the Unified CM that has the new codec.
f. Click Discover Rooms.
The new codec with the existing room name is added and the previous codec is removed from
CTS-Manager.