manual

5-7
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Codec—Part Number CTS-CODEC-SING-G1= or CTS-CODEC-SING1CH= (China Only)
Step 3 Remove the tie-wraps from around the cables by pressing the latch on the tie-wraps and removing them.
One of the tie-wraps is shown with callout 1 in Figure 5-4.
Figure 5-4 Removing the Tie Wraps around the Cable Bundles
Step 4
Detach the cables from the codec. Make a note of each cable connection. You can use the tape flags on
the cables for this purpose. If your cables do not have tape flags, you can make some with masking tape.
Step 5 Remove the two screws from each side of the codec (one on each side). These screws are at the top of
the codec. Save the screws.
Step 6 Rotate the codec backward and remove it from the metal bracket.
Step 7 Unpack the new codec.
Step 8 Determine the placement of the diagram on the codec and make sure that it is oriented correctly and on
the correct side of the codec and that it will not be upside-down.
Note The new codec comes with a wiring diagram with a self-adhesive backing.
Step 9 Peel off the adhesive backing on the diagram and place it on the codec.
Step 10 Place the codec in the bracket in the display assembly and secure it with the screws you saved in Step 5.
Step 11 Reconnect the cables. Use the tape flags or the wiring diagram on the codec as a guide.
209094
1