manual

5-23
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Cisco Unified IP Phone—Part Number CP-7975G-CTS=
Step 30 Press the Save softkey to save your changes.
After the configuration is saved, the IP phone will display the following text:
Updating CTL
Step 31 Press **# (Star-Star-Pound) to lock your phone configuration.
The Cisco Unified IP Phone reloads and bring up the Cisco TelePresence screen.
Step 32 Wait for the phone to complete its bootup procedure.
After the IP phone has successfully booted up and registered with the Call Manager, the IP phone ready
screen will display. See Figure 5-12 for an example of this screen.
Figure 5-14 IP Phone TelePresence Screen
Step 33
Check the status of the Cisco Unified IP Phone by completing the following steps:
a. Log in to the Cisco Telepresence System Administration GUI to verify the IP Phone status.
Tip To find TelePresence system IP address, press the More softkey, then press the Info softkey on the Cisco
Unified IP Phone.
b. Look in the System Status area on the lower left of the window.
c. Determine if there is a check mark next to Room Phone.