manual

5-21
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Cisco Unified IP Phone—Part Number CP-7975G-CTS=
Figure 5-12 IP Phone TelePresence Screen
Step 7
Check the status of the Cisco Unified IP Phone by completing the following steps:
a. Log in to the Cisco Telepresence System Administration GUI to verify the IP Phone status.
Tip To find TelePresence system IP address, press the More softkey, then press the Info softkey on the Cisco
Unified IP Phone.
b. Look in the System Status area on the lower left of the window.
c. Determine if there is a check mark next to Room Phone.
Step 8 Perform a test call to another Cisco TelePresence endpoint.
Note If the IP phone fails registering with Unified CM, contact your Unified CM administrator or your
authorized TelePresence representative.
Removing the Replacing the Cisco Unified IP Phone With Networks that Use a
Static IP Address
If your network uses a static IP address complete the following steps to replace your Cisco Unified
IP Phone.
Step 1 Unplug the Ethernet cable from the back of the existing Cisco Unified IP Phone.
The Ethernet port is marked as 10/100 SW.
Step 2 Make a note of the MAC Address of the new Cisco Unified IP Phone.
Find the MAC address on a white sticker on the rear of the phone, next to the Ethernet port.
Step 3 Log in to the Unified CM Administrative GUI.
Step 4 Enter the MAC address of the new Cisco Unified IP phone into the Administrative GUI.
The phone settings are stored in Unified CM and the MAC address is required for the phone to register
with Unified CM.