manual

5-19
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Cisco Unified IP Phone—Part Number CP-7975G-CTS=
Figure 5-11 Removing the Power Supply
Step 4
Place the new power supply in the slot behind the codec cover.
Step 5 Connect the power cord to the power supply to the power supply.
Step 6 Replace the codec you removed in Step 1 by following the procedure in the “Replacing the Codec—Part
Number CTS-CODEC-SING-G1= or CTS-CODEC-SING1CH= (China Only)” section on page 5-4.
Replacing the Cisco Unified IP Phone—Part Number
CP-7975G-CTS=
This section provides you with the steps you perform to replace the Cisco Unified IP Phone and includes
the following topics:
• Required and Optional Tools, page 5-20
• Removing the Replacing the Cisco Unified IP Phone With Networks that Use a Dynamic IP
Address, page 5-20
209270