manual

5-18
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Power Supply—Part Number CTS-CODEC-S-PWR=
Replacing the Power Supply—Part Number
CTS-CODEC-S-PWR=
This section provides you with the procedure to replace the codec for your system and includes the
following topics:
• Tools required, page 5-18
• Replacing the Power Supply, page 5-18
Tools required
One #2 Phillips screwdriver
Replacing the Power Supply
To remove the power supply, complete the following steps:
Step 1 Remove the codec by following the procedure in the “Replacing the Codec—Part Number
CTS-CODEC-SING-G1= or CTS-CODEC-SING1CH= (China Only)” section on page 5-4.
Step 2 Disconnect the power cord from the power supply. The cord is on the top of the supply.
Step 3 Pull the power supply out from behind the codec cover.