manual

5-12
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Rear Camera Cover—Part Number CTS500-32-CAM-CVR=
e. Delete the MAC address of the previous codec from the Cisco Unified CM application user profile
that is used in CTS-Manager.
f. Add the new codec to the application user profile and click Save.
Step 17 Power on the system by turning the power switches to the On position on the two left PDUs, single right
PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.
Step 18 Open a browser on a computer connected to the network.
Step 19 Type the IP address of the codec into the browser address bar.
Step 20 Enter the required information at the login screen. The Cisco TelePresence Administrator window
appears.
Step 21 Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 22 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
properly. For more information, see the “Manual First-Time Setup” section on page 4-31
Step 23 Perform the Auto Adjust camera setup procedure. This sets the white balance to the correct levels. See
the “Setting Up the Camera” section on page 4-33 for detailed instructions.
Step 24 Configure the codec in CTS-Manager by completing the following steps:
a. Log in to CTS-Manager as SysAdmin or Administrator.
b. Go to Configure > Application Settings.
c. Disable the Meeting Notification Email by selecting No for Enable Feature and clicking Apply.
d. Go to Configure > Unified CM.
Step 25 Select the Unified CM that has the new codec.
Step 26 Click Discover Rooms.
The new codec with the existing room name is added and the previous codec is removed from
CTS-Manager.
Replacing the Rear Camera Cover—Part Number
CTS500-32-CAM-CVR=
To replace the rear camera cover, complete the following steps:
Step 1 Unscrew the two screws that secure the rear camera cover to the display assembly.
Step 2 Unlatch the latch on the underside of the cover and lift it off the display assembly.