manual

5-10
Cisco TelePresence System 500-32 Installation, First-Time Setup, and Field-Replaceable Unit Guide
OL-23420-01
Chapter 5 Field-Replaceable Units and Region- and Country-Specific Power Cables
Replacing the Display Assembly—Part Number CTS500-32-INTDISP=
Step 3 Remove the tie-wraps from around the cables by pressing the latch on the tie-wraps. One of the tie-wraps
is shown with callout 1 in Figure 5-4.
Step 4 Detach the cables from the codec. Make a note of each cable position. You can use the tape flags on the
cables for this purpose. If your cables do not have tape flags, you can make some with masking tape.
Step 5 Remove the two screws from each side of the codec (one on each side). These screws are at the top of
the codec. Save the screws.
Step 6 Rotate the codec backward and remove it from the metal bracket. Save the codec.
Note You do NOT have to remove the power supply behind the codec; another one is supplied with the new
display assembly.
Step 7 Take the two cable bundles on each side of the display and route them downward behind the codec
bracket, until the two cable bundles hang on each side of the stand.
Figure 5-5 Routing the Cables Behind the Codec Bracket
209095