System information

6
Profile Series, Codec C Series and Quick Set C20 / C20 Plus Getting started guide
D14639.02 Profile Series, Codec C Series and Quick Set C20/C20 Plus Getting Started Guide TC4.0, November 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Wake up the system
If there is no menu on screen, press Home ( ) on the remote
control to show the menu.
If the system does not show a menu on screen:
Make sure the monitor is connected and has been turned on.
Make sure the remote control has the batteries installed.
Make sure the codec has been turned on.
If the system has just been turned on, wait a few minutes to allow the
system to start up.
If there is still no menu on screen, make sure the monitor cable is
connected to the basic video output connector. If in doubt, see the
Installation Sheet for your video system.
1
4
If you need to set a static IP address
If required, you can set a static IP address for your system.
To set a static IP address for IPv4:
1. Go to Settings > Advanced > IP settings > Configure.
2. Set IP Assignment to Static. Press OK ( ) to save the change.
3. Enter the IP Address, Subnet Mask and Gateway address. The
sequence is shown below. Contact your network administrator to
obtain the required IP addresses.
4. Select OK to save the changes, or Cancel to leave without saving.
5. Press Home ( ) to exit.
How to set a static IP address for IPv6, is described in the
Administrator guide of your product.
Verify IP address settings
To verify the IP address settings:
1. Go to Settings > System Information.
2. Check the Network > IP address section to see that the IP
address of the codec is shown on the System Information page.
3. Press Home ( ) to exit.
2
Initial configurations
When starting up the system for the first time, the menu
password is not set. Read more about password protection in the
Password protection section later in this guide.
Using the menu system
The menus on screen are easy accessible. You can navigate
in the menus using the remote control. Just lift up the remote
control and direct the remote towards the camera.
Using the web interface
If you know the IP address of the codec you can do the initial
configurations from the web interface.
Open a web browser and enter the IP address of the codec.
IP assignment: DHCP
IP Address
Subnet Mask
Gateway
OK
Cancel
IPV4 SETTINGS
Static
DHCP
IP assignment: Static
IP Address
Subnet Mask
Gateway
OK
Cancel
IPV4 SETTINGS
192.168.1.128
255.255.255.0
192.168.1.1
Select IP version
The system supports IPv4 and IPv6. To set the IP version:
1. Go to Settings > Advanced > IP settings > IP version.
2. Set IP version to IPv4 or IPv6 according to your requirement.
Press OK ( ) to save the change, or Cancel to leave without saving.
3. Press Home ( ) to exit.
3
Contents
Password protection
Introduction
Configure your system
The remote control
The menu system
The web interface
Configure your system