System information

11
Profile Series, Codec C Series and Quick Set C20 / C20 Plus Getting started guide
D14639.02 Profile Series, Codec C Series and Quick Set C20/C20 Plus Getting Started Guide TC4.0, November 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Waking up the system
To wake up the system just pick up the remote control or press any key. You may have
to point the remote control towards the system to make sure it discovers you.
IR sensor range (DIP switch setting)
The IR sensor has a short and long range. When video systems are placed close to each other,
you may find it convenient to use the short range to avoid interfering with the other video systems.
Open the battery cover and remove the batteries to set the DIP switch.
• Short range (1 m / 3 ft): Move the DIP switch down.
• Long range: Move the DIP switch up.
When you pick up the
remote control and
touch the rubber line
sensors along the
sides of the remote
control, the system
wakes up..
Press the HOME
key to show the
Home menu on
screen.
The DIP
switch
abc/123 #: Press and hold
the # key to toggle between
lower and upper case
characters and numbers
(depending on context).
0-9, a-z, period (.), @, space, *:
Press a key repeatedly to
toggle between the options
displayed on each key.
CALL KEY: Press the Call key
to place a call, and to accept an
incoming call.
Use the Call button as a shortcut
to Recent Calls when the Call
menu is not visible.
CLEAR: Press the
Clear key to remove
characters in a text field.
END CALL / STANDBY: Press the
End Call key to reject an incoming
call, to end an ongoing call or—when
idle—to go into standby mode. When
navigating in the menus the key is
used to exit the menu system.
Press and hold this key to have the
system enter standby mode.
ALPHANUMERIC KEYPAD
The keypad behaves in a similar way to the
keypad of a cellular phone.
Contents
Password protection
Introduction
Configure your system
The remote control
The menu system
The web interface
The remote control