Installation Guide
4 4027869 Rev A
Module Installation
Module Installation
Electrostatic Discharge Precautions
Electrostatic discharge (ESD) can cause damage to the plug-in Media Converter
modules that install into the chassis. Always observe the following precautions
when installing or handling a module or any board assembly.
1 Do not remove the module from its protective packaging until you are ready to
install it.
2 Wear an ESD wrist grounding strap before handling any module or component.
If you do not have a wrist strap, maintain grounded contact with the system unit
throughout any procedure requiring ESD protection.
CAUTION:
Prevent electrostatic damage to electronic equipment. Take ESD precautions,
including the use of an ESD wrist strap.
CAUTION:
Integrated circuits and fiber optic components are extremely susceptible to
electrostatic discharge damage. Do not handle these components directly
unless you are a qualified service personnel and use tools and techniques that
conform to accepted industry practices.
3 Hold boards by the edges only; do not touch the electronic components or gold
connectors.
4 After removal, always place the boards on a grounded, static free surface, ESD
pad, or in a proper ESD bag. Do not slide the board over any surface.
Installing SNMP Management Modules
In order to manage a chassis, the SNMP Management Module must be installed in
the first slot, on the far left of the chassis, using the card guides, and secured to the
chassis by tightening the captive screw.
The far left slot of the chassis is ONLY for the SNMP Management Module. Do not
install application modules such as media conversion and mode conversion modules
in this slot.