Installation Guide

12 4027869 Rev A
Configuring the Chassis
R – read-only access
W – read/write access
Enter – abort
4 Press Enter.
5 Type reboot for changes to take effect.
Result: The Saved Values and Current Values should now both display the
changes made (e.g., new IP address and subnet mask).
Deleting Community Strings
Follow these steps to delete all community strings and start over.
1 From the Main Configuration screen, press U.
2 Press Y to proceed OR press N to abort.
3 Press Enter.
Result: This function will delete ALL community strings. To selectively delete
community strings, use iConfig.
Assigning Trap Destinations
Manageable device sends traps when a certain events take place.
1 From the Main Configuration screen, press T.
2 Type the IP address of the destination device and press Enter.
3 Type the name of the community string (that the destination device has been
configured to accept) and press Enter.
Result: This function enables ALL of the traps the device is capable of. To
selectively activate and de-activate traps, use iConfig.
Removing Trap Destinations
Follow these steps to remove all trap destinations.
1 From the Main Configuration screen, press K.
2 Press Y to remove all trap destinations OR press N to abort.
3 Press Enter.
Changing Serial Password
The serial configuration does not have a default password. It is optional.