Installation Guide
10 4027869 Rev A
Configuring the Chassis
Saved Values — displays changes made during current session.
- IP Address (MUST be assigned during initial configuration)
- Subnet Mask (MUST be assigned during initial configuration)
- Default Gateway
Current Values — displays values currently in use.
- IP Address (IP address of SNMP agent)
- Subnet Mask (mask to define IP subnet agent is connected to)
- Default Gateway (default router for IP traffic outside subnet)
Command List
Command Description
I Enter New Saved Parameter Values
P Change Password
T New Trap Destination
K Remove ALL Trap Destinations
C New Community String
U Delete ALL Community Strings
D Enable/disable DHCP
E End Session
Space Bar Device Specific Configuration commands
Note: Reboot after making any modifications to the Saved Values or the changes
will not take effect. To reboot, type reboot at the prompt on the main configuration
screen, or turn the chassis OFF then ON again by turning off the switches on the
back of the power supplies.