System information

Step 4: Install the ICIM2

Note: Chassis can be ordered with or without ICIM ~ follow steps if adding ICIM to

non ICIM chassis

1. Remove the blanking panel covering the ICIM slot in the lower right

corner of the chassis back panel.

2. Hold the ICIM2-XD so that the front panel silkscreen is in correct reading

position.

3. Align the two ridges on the bottom of the ICIM2-XD with the module

guide slots located in the chassis.

4. Gently slide the ICIM2-XD into the chassis until its power and

communications connections join connectors on the back plane bus and

its front panel rests against the chassis.

5. Tighten the retaining screws on either side of the ICIM2-XD to secure to

chassis