System information

Step 2: Change Chassis ID Number

1. Locate the chassis ID switch at upper right on the front panel of each

chassis. The switch can be set to any two-digit value from 00 to 99 (but

avoid setting the value to 00, as explained below).

2. Use the chassis ID switch to set each chassis ID number to a unique

value.

Note:

 The chassis ID number can be changed while the chassis is under power.

However, the new ID number will not become effective until chassis power

is cycled or the ICIM2-XD is rebooted.

 The chassis numbering scheme used is discretionary, except that each

interconnected chassis must have a unique ID number.

CAUTION:

Setting the chassis ID to 00 is not recommended as it causes the entity MIB to violate

RFC-2737 by creating an invalid object identifier. This may affect operation with some

management systems that use the entity MIB. In particular, attempts to access the fans

(in virtual slot 0) in chassis 00 will fail if made via serial TNCS (or ROSA-EM) or LCI.