Specifications

1-74 Transmitters 4000326 Rev A
Configure Parameters Using the ICIM
Introduction
The CONFIG menu on the ICIM allows you to configure several transmitter
parameters.
Configuring Parameters
From the MAIN or SCROLL menus on the ICIM, navigate to the Prisma II 1310 nm
Forward Transmitter MODULE menu. From the MODULE menu, press the
CFG
key to display the CONFIG menu.
The following table shows the configurable parameters for the transmitter.
Parameter Description Values Default
Enable
Enables or disables transmitter
operation (turns the laser on or off).
• On or Off
On
CwMode
Automatically adjusts the displayed
RF input level by subtracting 3.0 dB
when CW mode is on. The RF high
alarm is also disabled when CW mode
is on.
• On or Off
Off
LoRFInh
Enables or disables the RF Input Low
alarm.
• On or Off
On
Master
Configures the module as master or
slave.
• If set to Master, the transmitter is
controlled only by the Enable
control above.
• If set to Slave, the transmitter is
controlled by a combination of
Enable and the external input
CNT_IN_1.
• Master or
Slave
Master
RFDrive
Sets the relative RF drive level into
the transmitter.
-1.5 dB to +1.5 dB
in 0.5 dB steps
0.0 dB